Oddbean new post about | logout
▲ ▼
BlackCoffee | 4 months ago (raw) | root | parent | reply | flag +1 
 I'd be terrified of a failure. I'll give it a go though. A couple of rolls of 2kg PLA / PETG I expect?

Also, check your telegram dms.
▲ ▼
BenGWeeks | 4 months ago (raw) | root | parent | reply | flag 
 Let me make a minor amendment to the backbox. One of triangular supports pushes the cash acceptor.
▲ ▼
BenGWeeks | 4 months ago (raw) | root | parent | reply | flag +1 
 About half a roll of 1kg at 10% for the backbox (thought it would be more!).
▲ ▼
BenGWeeks | 4 months ago (raw) | root | parent | reply | flag +1 
 As long as the first layer goes down OK you’re normally good. I’m printing this in PETG. Only issue I’ve had before on big printers is the edges lifting. Now have the enclosure for the MK3S+ and not had that issue since.

Will design up a sheet metal backbox design for a more secure version with the front facia rear mounted.