It looked like the side walls were slightly uneven so I spent some time using a spirit level tool to check each section of the walls. Any high bits were sanded down to make sure the walls were level with each other before attaching the base/bottom structure that I made in the last post. 

Now that the walls were nice and even, I flipped the walls upside down so I could attach the base structure to it. 

I lined up the bottom of the structure to the four walls and used tape to temporarily attach it together. Next, I drilled a bunch of holes through the bottom of the base and through the walls. 3 for each long wall and 2 for each short wall (10 screws total). I put the screws in and removed the tape. I then removed the screws and separated the base from the walls and added the glue to permanently join the two pieces together. I put the screws back in and left it to dry. It looked quite good with only a few small edges sticking out (easy to sand down).

#DIY #Bitcoin #Mining #Woodwork #Design #Glue